The Missouri Gravel Bed (MGB) is a method of handling bare
root nursery stock in which the plants are placed with their roots in an irrigated bed of
gravel and held for up to 6 months before planting. It is not a growing method, but can be
used by growers, nurseries, and arborists to extend the planting season and to greatly
simplify the handling of bare root stock. It also shows promise as a method for heeling in
B&B stock. The key is that root growth in gravel is very fibrous and unlike mulch or
sand, very few roots are damaged when plants are pulled from the gravel. The MGB was
developed at the University of Missouri Horticulture Research Center about 1985. In the
initial test, 20 - 4' to 6' bare root Washington Hawthorn trees, after 8 weeks in aerated
water, survived planting in midsummer. While aerated water grows good roots, it does not
provide any support, creating problems in plant handling. The studies since 1986 have used
creek gravel as the support and root growth medium.
Over the past 10 years, many species have been tested in the MGB including ornamental
pears, redbuds, flowering dogwood, lindens, maples, crabapples and roses. A test at
Sherman Nursery in 1994 expanded the number of species to well over 30. The survival of
MGB plants has been as good as or better than container grown or B&B materials.
There is nothing high tech about MGB. All that is required is a layer of gravel and a
time clock controlled irrigation system. Plants are simply placed with their roots in the
gravel, and allowed to grow until time to plant. A surface application of slow release
fertilizer has proven effective in keeping the plants green. Plastic Plumbing Products,
Grover, MO, has developed a drip irrigation kit designed for a 4' x 25' bed. Modules can
be added as needed, depending on the bed size desired. The kit includes a time clock and
solenoid valve and all of the required irrigation tubing and fittings.
Municipal arborists may be hesitant at first to buy plants with their roots out in the
open. However, the main reason why MGB works so well is that actively growing roots are
placed in direct contact with the soil. When plants are removed from the gravel, spraying
the roots with water and putting them in a plastic bag is sufficient. The plants should be
planted within a day or two. If the top growth is very soft, it may be advisable to wrap
the whole plant in plastic. Five or six times as many MGB plants will fit in a car as
container plants of the same size.
Layout: The beds can be constructed in 4' x 25' modules using 1/2" gravel with
about 10% sand (passing a #10 screen), 14" to 18" deep. Railroad ties or
dimension lumber can be used to make the bed look tidy. The drip irrigation lines should
be spaced 1 foot apart and running the length of the bed from a header across the 4'
width. Emitters (0.5 gph) are spaced every 6" in the line.
Bed Management: Plants are placed in the bed by digging a trench in the gravel and then
shoveling gravel back over the roots. It is helpful to wet the gravel before making the
trench. Spacing of plants in the bed will depend on the plant size. Staggered rows work
well for trees with 6'- 8' trees as close as 16" in the row. Up to 100 trees and
shrubs can be placed in a bed.
It is best to get the bed set up by mid April to allow for good root development before
the onset of hot temperatures. Until plants leaf out, watering I is not critical. Set the
time clock to water two or three times a day for about 5 minutes. When the plants have
begun to flush, set the time clock to irrigate about 3 or 4 minutes every hour during the
daylight hours. Later, when the growth has slowed, the irrigation frequency can be reduced
to once or twice per day. Let the plants be your guide. Slow release fertilizer granules
should be applied to the surface of the gravel. Use a rate similar to that for topdressing
container stock but apply at monthly intervals.
Planting: When removing plants from the gravel, lay the plants on a piece of plastic
and spray them with water. A bundle of five or ten plants can be wrapped up and tied with
twine. If the bundle is not opened and kept in a cool place, the plants can be kept for
several days before planting. Dipping the roots in TerraSorb gel does not seem to provide
any real benefit and may actually interfere with root growth in some cases. It is best to
check occasionally and spray the roots with water. Later in the season, after the top
growth has hardened, the roots can be placed in a bag and the tops left exposed. Water
added to the planting hole is often the only care required as the roots begin taking up
water from the backfill soil immediately.
Chris is a Professor of Horticulture at the University of Missouri - Columbia. Chris
can be contacted at (573) 882-9630. Plastic Plumbing Products can be contacted at (314)
458-2226.